TUW-3280 Electronic fluorinated liquid CAS NO:338-83-0

Số CAS

 

TUW-3280 Electronic fluorinated liquid CAS NO:338-83-0

Introduction
TUW    Electronic fluorinated liquid TUW-3280 is a clear, colourless, thermally stable, fully-fluorinated liquid ideal for use in many single phase heat transfer applications in the semiconductor manufacturing industry. Its liquid range (-50°C to 122°C) makes it ideal for a variety of applications such as etchers, ion implanters, testers and others. Because liquid TUW-3280
is primarily a single compound, its composition will not shift or fractionate with time. This keeps fluid loss to a minimum and insures that transport properties will not change with time.

Physical Properties

Boiling point:     122°C
Appearance:    Transparent liquid
Colour:    colourless
Dielectric constant:     1.96
Dielectric strength:     48 KV
surface tension:     12.7mN/m
Density:     1.83g/ml
Saturated water content:     50ppm
PH value:     7
Flash point:     None
Fuel range:     None
ODP:     0
GWP:     low
Specific heat 25 °C:     1.431 J/g°C
Thermal conductivity 25 °C:     0.0834
Heat ofvaporization:     136 J/g°C
Viscosity 25 °C:     1.32cst
Chemical name:     Perfluoroamine
CAS:     338-83-0
Pour point:     -50℃
Freeze point:     -61℃

 

TUW Electronic fluorinated liquid TUW-3280 Materials Compatibility
TUW Electronic fluorinated liquid TUW-3280 liquid is compatible with most metals, plastics and elastomers.

Toxicity Profile

1. Ideal chemical inertness, which can be widely used in various temperature control and heat dissipation occasions, such as liquid cooling safety protection of energy storage lithium battery.
2. Single phase cooling has low pressure increase, which can reduce the sealing requirements of the equipment, save consumption in later maintenance and reduce the cost.
3. Non dangerous goods will not explode or have no ignition point
4. Good electrical insulation, with extremely high breakdown voltage greater than 40kV.
5. Dielectric constants below 2 will not lose data in data center applications.
6. Good fluidity and lower viscosity than that of clean water; It can flow and dissipate heat in the temperature control system.
7. Non toxic, harmless and non irritating
8. Environment friendly, with 0 ODP value and very low GWP value.

Toxicity Profile
Electronic fluorinated liquid tuw-3280 has no irritation to the skin, the least irritation to the eyes after contact, and is almost non-toxic when taken orally. Material safety data sheets are available on request.

Safety and Handling

Before using this product, please read the current product Material Safety Data Sheet (available through your TUW sales or technical service representative) and the precautionary statement on the product package. Follow all applicable precautions and directions. Electronic fluorinated liquid TUW-3280 liquid is nonflammable, and is highly resistant to thermal breakdown and hydrolysis in storage and during use. Recommended handling procedures are given in the Material Safety Data Sheet.

 

Environmental Properties

Electronic fluorinated liquid TUW-3280 has zero ozone depletion potential. TUW-3280 Electronic fluorinated liquid, a perfluorocarbon (PFC), has a high global warming potential and a long atmospheric lifetime. As such, it should be carefully managed so as to minimize emissions.

T U W recommends that users of TUW-3280 Electronic fluorinated liquid further limit emissions by employing good conservation practices, and by implementing recovery, recycling and/or proper disposal procedures. TUW offers a program for used fluid return

 

Environmental Policy
TUW will recognize and exercise its responsibility to:
•prevent pollution at the source wherever and whenever possible
•develop products that will have a minimal effect on the environment